The rear axle ladder bar kit shown left was donated for use on the NSRA 2005 give away car. The ladder bars are made from 7/8” x 3/16” CDS with the 5/8” UNF thread tapped directly into the tube and a laser cut fishplate is added to stiffen the assembly. A bonded rubber, steel lined, bush is fitted into a specially machined mild steel housing and a set of our mild steel clevis and lock nuts used at the axle end. The whole assembly is TIG welded and 10-mm mild steel, laser cut axle bracket is added. A set of our extra long chassis brackets, which allow for trimming to…